|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This service is relatively cheap, document is fast available, schematic is readable.
Thanks.
 ;
So far I´m a satisfied customer. I have only downloaded "TECHNICS SX-KN470 Service Manual" maybe I will use it later.
Best regards
Peter
;
Good manual. It is complete and of high quality, both text and graphics. The schematics are with the original big size, so it can be viewed or printed without any loss of resulution and sharpness.
;
We needed a manual quickly...online it was available immediately, at a very low price. We loved the convenience!
;
Excellent!!
Got what I need and very fast!!
Thank You
F. NOISE FILTER ASS'Y HIGH VOLTAGE DIODE, HIGH VOLTAGE CAPACITOR, AND COOLING FAN MOTOR REMOVAL
1 ) Disconnect lead wires from the noise filter ass'y and remove screw securing the noise filter earth wire to the back plate. 2) Push two hook of the guide suction and lift up the rear of noise filter ass'y. 3) Disconnect lead wires from H.V. capacitor and remove screw securing the H.V. diode earth wire to the back plate. 4) Disconnect each lead wires from the AC relay and the fan motor. 5) Remove two screws securing the guide suction ass'y to the back plate and lift up the guide suction ass'y. 6) Remove one screw from H.V. capacitor bracket. 7) Pull H.V. capacitor bracket from the guide suction. 8) Remove the fan from the fan motor. guide suction and lift it up. 9) Remove two screws securing the fan motor to the
H.V. Transformer
I. C-MOTOR, THERMISTOR AND SHEATH HEATER REMOVAL
1) Remove the two screws securing the cover assembly to the oven cavity. 2) Disconnect the leadwire from the circulation motor terminal and the sheath heater. 3) Remove the screws of the thermistor, guide assychamber and lift up the guide assy-chamber. 4) Remove a hex nut securing the circulation fan to shaft of the C-motor. 5) Remove screws securing the motor bracket to the guide assy-chamber. 6) Remove two hex nuts securing the C-motor to the motor bracket.
G. OVEN LAMP REMOVAL
1) Disconnect the wire leads from oven lamp. 2) Remove one screw securing the Air Duct to the magnetron. 3) Push hook to Right and Left of Air Duct, with Drive. 4) Lift the oven Lamp up.
H. HIGH VOLTAGE TRANSFORMER REMOVAL
1) Disconnect the wire leads from the transformer to the magnetron, C. Protector ASS'Y assembly. 2) Remove four screws securing the H.V. transformer to the base plate. 3) Lift the H.V. transformer up.
5-6
|
|
|
> |
|
